Removal

2GR-FE LUBRICATION: OIL PUMP: REMOVAL

1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

Removal

2. REMOVE VANE PUMP ASSEMBLY Removal

3. INSTALL ENGINE HANGER Removal

4. REMOVE FRONT FRAME ASSEMBLY Removal

5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

6. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

7. REMOVE ENGINE WIRE

8. REMOVE STARTER ASSEMBLY Removal

9. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

Removal

10. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY Removal

11. SECURE ENGINE Removal

12. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Removal

13. REMOVE IGNITION COIL ASSEMBLY Removal

14. REMOVE NO. 2 ENGINE MOUNTING STAY RH Removal

15. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH Removal

16. REMOVE OIL LEVEL GAUGE GUIDE SUB-ASSEMBLY Removal

17. REMOVE NO. 2 MANIFOLD STAY Removal

18. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR Removal

19. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal

20. REMOVE ENGINE MOUNTING BRACKET RH Removal

21. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY Removal

22. REMOVE NO. 2 TIMING GEAR COVER Removal

23. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY Removal

24. REMOVE WATER PUMP PULLEY Removal

25. REMOVE RADIO SETTING CONDENSER Removal

26. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY Removal

27. REMOVE NO. 1 OIL PIPE Disassembly

28. REMOVE OIL PIPE Disassembly

29. REMOVE CRANKSHAFT PULLEY Disassembly

30. REMOVE NO. 1 ENGINE MOUNTING BRACKET FRONT LH Disassembly

31. REMOVE WATER INLET HOUSING Disassembly

32. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY RH Disassembly

33. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY LH Disassembly

34. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY Disassembly

35. REMOVE OIL STRAINER SUB-ASSEMBLY Disassembly

36. REMOVE OIL PAN SUB-ASSEMBLY Disassembly

37. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

(a) Remove the 23 bolts and 2 nuts as shown in the illustration.





(b) Remove the timing chain cover by prying between the timing chain cover and cylinder head or cylinder block with a screwdriver.





NOTICE:
Be careful not to damage the contact surfaces of the cylinder head, cylinder block and chain cover.

HINT
Tape the screwdriver tip before use.

(c) Remove the gasket.





38. REMOVE TIMING CHAIN CASE OIL SEAL

(a) Using a screwdriver, pry out the oil seal.





HINT
Tape the screwdriver tip before use.