Installation

SUSPENSION: FRONT STABILIZER BAR: INSTALLATION

1. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING

(a) Install the 2 front stabilizer bar bushings No. 1 to the outside of the bushing stopper on the front stabilizer bar.





NOTICE:
Make sure that the cutout of the front stabilizer bar bushing No. 1 faces the rear side as shown in the illustration.

2. INSTALL FRONT NO. 1 STABILIZER BRACKET LH

(a) Install the front No. 1 stabilizer bracket LH.

3. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

(a) Install the front No. 1 stabilizer bracket RH.

4. INSTALL FRONT STABILIZER BAR

(a) Install the front stabilizer bar with the 2 bolts. (LH Side)





Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

(b) Install the front stabilizer bar with the 2 bolts. (RH Side)





Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

5. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT
Refer to the instructions for installation of the engine assembly Installation.

6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

(a) Install the front stabilizer link assembly LH with the 2 nuts.





Torque : 74 Nm (755 kgf-cm, 55 ft-lbf)

HINT
If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

(a) Install the front stabilizer link assembly RH with the 2 nuts.





Torque : 74 Nm (755 kgf-cm, 55 ft-lbf)

HINT
If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

8. CONNECT TIE ROD END SUB-ASSEMBLY Installation

9. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY Installation

10. PLACE FRONT WHEELS FACING STRAIGHT

11. INSTALL FRONT WHEELS

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Front Wheel Alignment