Tire and Wheel System

TIRE AND WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION

1. INSPECT TIRE

(a) Check the tires for wear and proper inflation pressure.

Cold tire inflation pressure:





(b) Using a dial indicator, check the runout of the tires.





Tire runout:

1.0 mm (0.039 in.) or less

2. ROTATE TIRE

(a) Rotate the tires as shown in the illustration.





3. INSPECT WHEEL BALANCE

(a) Check and adjust the off-the-car balance.





(b) If necessary, check and adjust the on-the-car balance.





Imbalance after adjustment:

8.0 g (0.018 lb) or less

NOTICE:
* Remove dirt, oil and water from the surface where the balance weight is to be adhered with a cleaning detergent.
* Do not touch the sticking surface of the tape.
* Adhere the sticking type balance weight to the flat position shown in the illustration.
* Push the balance weight securely with a finger to adhere it to the position.
* Do not reuse balance weight.
* Please use the LEXUS genuine sticking type balance weight.

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

(a) Inspect front axle hub bearing looseness .

5. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Inspect rear axle hub bearing looseness .

6. INSPECT FRONT AXLE HUB RUNOUT

(a) Inspect front axle hub runout .

7. INSPECT REAR AXLE HUB RUNOUT

(a) Inspect rear axle hub runout .