Luggage Compartment Door Opener System

ENGINE HOOD / DOOR: LUGGAGE COMPARTMENT DOOR OPENER SYSTEM: TERMINALS OF ECU

1. CHECK COWL SIDE JUNCTION BLOCK RH (MULTIPLEX NETWORK BODY ECU)

(a) Disconnect the DK and DD junction block connectors.

(b) Disconnect the K68 and K67 connectors.





(c) Measure the voltage and resistance according to the value(s) in the table below.





If the result is not as specified, there may be a malfunction on the wire harness side connectors.

2. CHECK COWL SIDE JUNCTION BLOCK LH (COWL SIDE JUNCTION BLOCK ECU LH)

(a) Disconnect the PM and PA junction block connectors.

(b) Disconnect the V3 ECU connector.





(c) Measure the voltage and resistance according to the value(s) in the table below.





If the result is not as specified, there may be a malfunction on the wire harness side.

(d) Reconnect the PM and PA junction block connectors.

(e) Reconnect the V3 ECU connector.

(f) Measure the voltage and resistance according to the value(s) in the table below.





If the result is not as specified, the cowl side junction block ECU LH may have a malfunction.