Removal

BRAKE: REAR BRAKE: REMOVAL

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.

1. REMOVE ABS MOTOR RELAY (for 1UR-FSE)

(a) Remove the 2 ABS motor relays with the engine switch off.





2. REMOVE REAR WHEEL

3. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.

4. REMOVE DISC BRAKE PAD KIT REAR

(a) Disengage the both ends of the anti-squeal spring from the 2 brake pad holes, and turn the anti-squeal spring as shown in the illustration.





(b) Push the pin hold clip toward the brake rotor to disengage it from the brake pad, and then remove it from the 2 pad guide pins.





NOTICE:
Be sure to remove the pin hold clip as specified above.

(c) Holding the anti-squeal spring, remove the 2 pad guide pins from the rear disc brake cylinder assembly.





(d) Remove the anti-squeal spring from the rear disc brake cylinder assembly.

(e) Remove the 2 brake pads with the anti-squeal shims.

5. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

(a) Remove the 2 anti-squeal shims from each pad.

6. DISCONNECT REAR BRAKE FLEXIBLE HOSE

(a) Remove the union bolt and gasket from the rear disc brake cylinder, and then disconnect the flexible hose.





7. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN

(a) Remove the cylinder slide pin and then tilt the disc brake cylinder toward the rear of the vehicle.





8. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH

(a) Remove the 2 bolts and rear disc brake cylinder together with the caliper support bracket.

(b) Remove the 2 No. 1 caliper plates from the caliper support bracket.