Installation

2GR-FSE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

1. INSTALL V-RIBBED BELT

(a) Install the V-ribbed belt.





While turning the belt tensioner counterclockwise, remove the 5 mm hexagon wrench.

NOTICE:
* Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
* Check that the V-ribbed belt is properly set to each pulley.





If it is difficult to install the V-ribbed belt, perform the following procedure.

(1) Put the V-ribbed belt on every part except the tensioner pulley as shown in the illustration.

(2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.

NOTICE:
* Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
* Check that the V-ribbed belt is properly set to each pulley.

2. INSTALL NO. 1 AIR CLEANER INLET

(a) Install the air cleaner inlet with the bolt.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

3. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

4. INSTALL COOL AIR INTAKE DUCT SEAL Installation