B1242

DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM: B1242: Wireless Door Lock Tuner Circuit Malfunction
B1242 - Wireless Door Lock Tuner Circuit Malfunction

DESCRIPTION

This DTC is output when one of the following occurs: 1) short in RDA or RSSI ground between the certification ECU and the door control receiver or 2); short RDA or RSSI ground when RC0 (5 V) output from the ECU is off.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK WIRE HARNESS (CERTIFICATION ECU - DOOR CONTROL RECEIVER)

(a) Disconnect the U28 ECU connector.





(b) Disconnect the U36 receiver connector.

(c) Measure the resistance of the wire harness side connectors.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK CERTIFICATION ECU (SUPPLY VOLTAGE)

(a) Disconnect the U36 receiver connector.





(b) Measure the voltage of the ECU.

Standard voltage:





NG -- REPLACE CERTIFICATION ECU
OK -- Continue to next step.

3. CHECK DOOR CONTROL RECEIVER (+B TERMINAL)





(a) Reconnect the U36 receiver connector.

(b) Measure the voltage of the connector.

Standard voltage:





NG -- REPLACE DOOR CONTROL RECEIVER Removal
OK -- Continue to next step.

4. CHECK DOOR CONTROL RECEIVER (OPERATION)

(a) Temporarily replace the door control receiver with a new or normally one.

(b) Perform the REGISTRATION procedures Engine Immobilizer System.

NEXT -- Continue to next step.

5. CHECK FOR DTC

(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

(b) Check if the same DTC is not output.

OK:

DTC B1342 output does not reoccur.

NG -- REPLACE CERTIFICATION ECU

OK -- END (DOOR CONTROL RECEIVER IS DEFECTIVE)