Electronically Controlled Brake System
BRAKE CONTROL: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART
HINT
* If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.
* Inspect the fuses and relays before investigating the trouble areas as shown in the table below.
ABS DTC
HINT
* In some cases, the Techstream cannot be used when ABS warning light remains on.
* When U0073/94, U0293/59, U0123/62, U0124/95, U0126/63, U0130/68 or U0131/67 is output, inspect and repair the trouble areas indicated by these codes first.
* Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.
(1) Drive the vehicle at a speed of 50 km/h (31 mph) and depress the brake pedal strongly for approximately 3 seconds.
(2) Repeat the above operation 3 times or more and check that the ABS warning light goes off.
(3) Clear the DTCs.
VSC DTC
Electronically Controlled Brake System DTC
ABS and Electronically Controlled Brake System DTC
HINT
* *1: for Electronically controlled brake system function
* *2: for ABS function
ABS Test Mode DTC
VSC Test Mode DTC
Electronically Controlled Brake System Test Mode DTC