Reassembly

SLIDING ROOF: SLIDING ROOF HOUSING: REASSEMBLY

1. INSTALL ROOF WIND DEFLECTOR PANEL ASSEMBLY

(a) Attach the 2 claws and install the wind deflector panel.

2. INSTALL SLIDING ROOF DRIVE CABLE ASSEMBLY

NOTICE:
Check and be sure that the spring indicated by the arrow in the illustration is securely installed.





(a) Hold down the roof wind deflector panel assembly.





(b) Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.





HINT
* Hold the roof wind deflector panel assembly down until the sliding roof drive cable assembly runs on the roof wind deflector panel assembly.
* Tape the screwdriver tip before use.

(c) Install the 2 sliding roof side stoppers with the 2 screws.

3. INSTALL REAR ROOF DRIP CHANNEL





(a) Move the rear roof drip channel forward from the rear side of the sliding roof housing, and install the rear roof drip channel to the sliding roof housing.

(b) Attach the 2 claws and install the rear roof drip channel.

4. ADJUST SLIDING ROOF DRIVE CABLE ASSEMBLY

(a) Using a screwdriver, align the matchmarks by sliding the drive cable in the direction indicated by the arrow in the illustration.





HINT
Tape the screwdriver tip before use.

5. INSTALL SUNSHADE TRIM ASSEMBLY

(a) Install the 2 sliding roof panel stoppers and trim.

(b) Install the screw and sliding roof piece LH.

(c) Install the screw and sliding roof piece RH.

6. INSTALL SLIDING ROOF DRIVE GEAR ASSEMBLY

(a) Install the drive gear with the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(b) Attach the bracket's claw to install the bracket.