Installation

BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION

HINT
* Use the same procedures for the LH side and RH side.
* The procedures listed below are for the LH side.

CAUTION:
When the brake caliper is removed from the brake disc, do not start the hybrid system. If the hybrid system is started, the brake fluid pressure may increase.

1. INSTALL FRONT SPEED SENSOR LH

(a) Wipe off sealant attached to the sensor's fitting surface with non-residue solvent.

NOTICE:
Prevent foreign matter from attaching to the sensor rotor.

(b) Install a new sensor to the hub and bearing. The sensor connector should be placed in the upper position.





(c) Using SST and a press, press in the speed sensor to the hub and bearing.





NOTICE:
* Keep the sensor away from magnets.
* Do not use a hammer on the sensor.
* Check that there is no foreign matter such as iron chips on the sensor's detecting portion.
* Slowly press the sensor straight.

2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH Installation

3. CHECK FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

4. CHECK FRONT AXLE HUB RUNOUT Front Axle Hub

5. INSTALL FRONT DISC Reassembly

6. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Installation

7. CONNECT CONNECTOR

(a) Connect the sensor connector to the front speed sensor.

NOTICE:
Do not twist the sensor wire.





8. INSTALL FRONT WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

9. CHECK SPEED SENSOR SIGNAL

(a) Check the speed sensor signal Test Mode Procedure.