Removal
2GR-FSE LUBRICATION: OIL PUMP: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE ENGINE ASSEMBLY
(a) Remove the engine Removal.
3. INSTALL ENGINE STAND
4. REMOVE ENGINE WIRE Removal
5. REMOVE OIL DIPSTICK GUIDE SUB-ASSEMBLY Removal
6. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal
7. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH Removal
8. REMOVE FAN & GENERATOR V BELT Removal
9. REMOVE NO. 2 ENGINE COVER Removal
10. REMOVE NO. 1 ENGINE COVER Removal
11. REMOVE ELECTRIC INVERTER COMPRESSOR Removal
12. REMOVE ENGINE MOUNTING BRACKET LH Removal
13. REMOVE ENGINE MOUNTING BRACKET RH Removal
14. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY Removal
15. REMOVE WATER PUMP PULLEY Removal
16. REMOVE INJECTOR DRIVER Removal
17. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Removal
18. REMOVE NO. 2 SURGE TANK STAY Removal
19. DISCONNECT WATER HOSE JOINT
20. REMOVE CRANKSHAFT PULLEY Disassembly
21. REMOVE WATER INLET Disassembly
22. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY Disassembly
23. REMOVE OIL STRAINER SUB-ASSEMBLY Disassembly
24. REMOVE OIL PAN SUB-ASSEMBLY Disassembly
25. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY Removal
26. REMOVE NO. 1 FUEL PIPE Removal
27. DISCONNECT NO. 2 FUEL PIPE Removal
28. REMOVE FUEL PUMP ASSEMBLY Removal
29. REMOVE NO. 2 FUEL PIPE Removal
30. REMOVE IGNITION COIL ASSEMBLY Removal
31. REMOVE NO. 1 OIL PIPE Disassembly
32. REMOVE NO. 2 OIL PIPE Disassembly
33. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 1) Disassembly
34. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY (for Bank 2) Disassembly
35. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
(a) Remove the bolt and wiring harness clamp bracket.
(b) Remove the 25 bolts and 2 nuts shown in the illustration.
(c) Remove the timing chain cover by prying between the timing chain cover and cylinder head or cylinder block with a screwdriver.
NOTICE:
Be careful not to damage the contact surfaces of the cylinder head, cylinder block and chain cover.
HINT
Tape the screwdriver tip before use.
(d) Remove the gasket.
