Removal

L110 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: REMOVAL

1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

2. REMOVE BATTERY SERVICE HOLE COVER LH Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

4. REMOVE COOL AIR INTAKE DUCT SEAL Removal

5. REMOVE ENGINE ROOM SIDE COVER RH Removal

6. REMOVE ENGINE ROOM SIDE COVER LH Removal

7. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

8. REMOVE FRONT UPPER FENDER PROTECTOR LH Removal

9. REMOVE FRONT UPPER FENDER PROTECTOR RH Removal

10. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

11. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

12. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal

13. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal

14. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

15. DRAIN ENGINE COOLANT Service and Repair

16. SEPARATE NO. 2 VENTILATION HOSE Removal

17. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE Removal

18. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY Removal

19. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Removal

20. REMOVE NO. 2 ENGINE UNDER COVER Removal

21. DRAIN TRANSMISSION FLUID Removal

22. REMOVE HEATED OXYGEN SENSOR

(a) Remove the heated oxygen sensor Removal.

23. REMOVE FRONT FLOOR BRACE CENTER Removal

24. REMOVE REAR FLOOR NO. 1 PANEL BRACE Removal

25. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

26. REMOVE AIR GUIDE PLATE OUTSIDE RH

(a) Remove the 4 nuts, and air guide plate outside RH.

27. REMOVE FRONT FLOOR COVER CENTER RH

(a) Remove the 3 grommets, and front floor cover center RH.

28. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR Removal

29. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY Removal

30. REMOVE OIL COOLER TUBE Removal

31. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

(a) Set the shift lever to the neutral position.

(b) Remove the nut, and separate the floor shift gear shifting rod sub-assembly.

32. SUPPORT HYBRID VEHICLE TRANSMISSION ASSEMBLY

(a) Support the hybrid vehicle transmission assembly with a transmission jack.

33. SEPARATE REAR ENGINE MOUNTING INSULATOR ASSEMBLY

(a) Remove the 4 bolts, and separate the rear engine mounting insulator from the body.

34. REMOVE SHIFT LEVER POSITION SENSOR

(a) Tilt down the hybrid transmission assembly.

(b) Disconnect the shift lever position sensor connector.

(d) Using a screwdriver, pry out the lock washer.

(e) Remove the lock nut and lock washer.

(f) Remove the 2 bolts and shift lever position sensor.