Pinout Values and Diagnostic Parameters

ENGINE HOOD / DOOR: FUEL LID OPENER SYSTEM: TERMINALS OF ECU

1. CHECK BODY ECU (COWL SIDE JUNCTION BLOCK LH)

(a) Disconnect the PA, PD and PL junction block connectors.





(b) Measure the voltage and resistance according to the value(s) in the table below.





If the result is not as specified, there may be a malfunction on the wire harness side connectors.

(c) Reconnect the PA, PD and PL junction block connectors.

(d) Measure the voltage according to the value(s) in the table below.





If the result is not as specified, the junction connector may have a malfunction.

2. CHECK INTEGRATION CONTROL AND PANEL ASSEMBLY

(a) Disconnect the K12 panel connector.





(b) Measure the voltage and resistance according to the value(s) in the table below.





If the result is not as specified, there may be a malfunction in the wire harness side connectors.