Installation

SLIDING ROOF: SLIDING ROOF HOUSING: INSTALLATION

1. INSTALL SLIDING ROOF HOUSING ASSEMBLY

(a) Temporarily install the housing with the 4 bolts (vehicle body side) and 8 nuts.

CAUTION:
Be careful not to damage the curtain shield airbag when installing the housing.

(b) Tighten the nuts in step (a).

Torque : 5.5 Nm (55 kgf-cm, 48 in-lbf)

(c) Tighten the 4 bolts on the housing side of the stay.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Tighten the bolts in step (a).

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(e) Connect the 4 drain hoses.

2. INSTALL SLIDING ROOF GLASS ASSEMBLY

(a) Using a T25 "torx" driver, temporarily install the glass with the 4 screws.

(b) Adjust the roof glass position.

(1) Check the clearance between the roof glass and roof panel.

(2) Using a T25 "torx" driver, loosen the 4 screws and adjust the roof glass position.





Standard:





NOTICE:
The clearance should be even all around.

(3) Check the clearance between the roof panel and roof glass.

(c) Tighten the 4 screws in step (a).

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

3. INSPECT FITTING OF SLIDING ROOF GLASS ASSEMBLY

If a leak is found, readjust the sliding roof.

4. INSTALL ROOF HEADLINING ASSEMBLY

Install the roof headlining. Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION

Perform initialization. Repair Instruction - Initialization

CAUTION:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.