Rear Axle Hub

AXLE: REAR AXLE HUB: ON-VEHICLE INSPECTION

1. REMOVE REAR WHEEL

2. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY Removal

3. REMOVE REAR DISC Disassembly

4. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, check for looseness near the center of the axle hub.





Maximum:

0.05 mm (0.0020 in.)

NOTICE:
Ensure that the dial indicator is set at right angles to the measurement surface.

If looseness exceeds the maximum, replace the axle hub assembly.

5. INSPECT REAR AXLE HUB RUNOUT

(a) Using a dial indicator, check for runout on surface of the axle hub outside the hub bolt.





Maximum:

0.05 mm (0.0020 in.)

NOTICE:
Ensure that the dial indicator is set at right angles to the measurement surface.

If runout exceeds the maximum, replace the axle hub assembly.

6. INSTALL REAR DISC Reassembly

7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Installation

8. INSTALL REAR WHEEL