Removal
1UR-FSE IGNITION: IGNITION COIL AND SPARK PLUG: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working Service Precautions.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
3. REMOVE COOL AIR INTAKE DUCT SEAL Removal
4. REMOVE ENGINE ROOM SIDE COVER LH Removal
5. REMOVE ENGINE ROOM SIDE COVER RH Removal
6. REMOVE NO. 1 AIR CLEANER INLET Removal
7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal
8. REMOVE SKID CONTROL ECU Removal
9. REMOVE BATTERY Removal
10. REMOVE NO. 1 BATTERY TRAY SUPPORT
11. REMOVE POWER STEERING ECU ASSEMBLY Removal
12. REMOVE BATTERY TRAY
(a) Remove the 2 bolts and battery tray.
13. SEPARATE NO. 1 ENGINE ROOM RELAY BLOCK ASSEMBLY
(a) Remove the 2 bolts and nut.
14. REMOVE WIRE HARNESS CLAMP BRACKET
(a) Remove the 2 wire harness clamps.
(b) Remove the bolt, wire harness clamp bracket and wire harness clamp.
15. REMOVE IGNITION COIL ASSEMBLY
(a) Disconnect the 8 ignition coil connectors.
(b) Remove the 8 bolts.
(c) Using a screwdriver, pry at the cutouts to remove the 8 ignition coils together with the 8 spark plug tube gaskets.
NOTICE:
Do not damage the cylinder head cover when removing the spark plug tube gasket.
HINT
Tape the screwdriver tip before use.
16. REMOVE SPARK PLUG
(a) Using a 16 mm plug wrench, remove the 8 spark plugs.