Adaptive Variable Suspension System
SUSPENSION CONTROL: ADAPTIVE VARIABLE SUSPENSION SYSTEM: PRECAUTION
NOTICE:
* When there is a malfunction in the contact point of the terminals or installation problems with parts, removal and installation of the suspected problem parts may return the system to the normal condition either completely or temporarily.
* In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, sure as by DTC output and record it before disconnecting each connector or removing and installing parts.
* Since the Adaptive Variable Suspension system (AVS system) may be influenced by a malfunction in other systems, be sure to check for DTCs in the other systems.
* When removing and installing the absorber control ECU and each sensor, be sure to check that the normal display is output in Test Mode inspection and in DTC output inspection after installing all the parts.
* The CAN communication system is used for data communication between each of the ECUs and sensors. If there is trouble in the CAN communication line, the DTC of the communication line is output.
* If the DTC of the CAN communication line is output, repair the malfunction in the communication line and troubleshoot the AVS system.
* Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.
* While using the batteries for inspection, do not place the positive and negative tester probes too close to each other as a short circuit may occur.
* When disconnecting the negative (-) battery cable, initialize the following systems after the cable is reconnected.
