Canada - Instruments - Calibration of Compass
BulletinTSB2818
Issue Date
July 21, 2010
Title
INITIAL CALIBRATION OF COMPASS DURING PDS
Component
GENERAL INFORMATION
Models
'11 GS350; GS460
INTRODUCTION:
Some 2011 model year GS350; GS460 vehicles are equipped with a compass in the rear view mirror. Use the following procedure to perform initial calibration during Pre-Delivery Service (PDS).
APPLICABILITY:
WARRANTY INFORMATION:
CALIBRATION PROCEDURE:
1. Push the "POWER" switch to select "IG-ON" mode.
2. Push and hold the "AUTO" switch for 6 seconds until the zone number (1 - 15) appears on the display.
NOTE
Pushing the "AUTO" switch turns the compass display ON or OFF.
3. Push the "AUTO" switch to select the number of the zone where the vehicle is located.
See the map in figure 3 for zone reference.
4. Start the engine/hybrid system, and push and hold the "AUTO" switch for 12 seconds until "CAL" appears on the display.
5. Drive the vehicle slowly at 8 km/h (5 mph), or less, in a circle until the direction is displayed. If there is NOT enough space to drive in a circle, drive around the block until the direction is displayed.
Once the direction is displayed, the calibration is complete.
NOTE
- Do NOT perform calibration of the compass in a place where the Earth's magnetic field is subject to interference by artificial magnetic fields (underground parking, under a steel tower, between buildings, roof parking, near a railroad crossing, near a large vehicle, etc.)
- During calibration, do NOT operate electric systems (moon roof, power windows, etc.) as they may interfere with the calibration.