Cellular Phone cannot Send/Receive

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: Cellular Phone cannot Send/Receive
- Cellular Phone cannot Send/Receive

INSPECTION PROCEDURE

NOTICE:
After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary. (w/ SDARS System)

PROCEDURE

1. CHECK "Bluetooth" SETTINGS

(a) Check if the "Bluetooth" settings are correct.

OK:

"Bluetooth" settings are correct.

NG -- SET SETTINGS CORRECTLY
OK -- Continue to next step.

2. CHECK CELLULAR PHONE

(a) Check if the cellular phone is "Bluetooth" compatible.

HINT
Some versions of "Bluetooth" compatible cellular phones may not function.

OK:

The phone is "Bluetooth" compatible.

NG -- END (ONLY A "Bluetooth" COMPATIBLE CELLULAR PHONE CAN BE USED)
OK -- Continue to next step.

3. CHECK SETTINGS

(a) Check the cellular phone functions.

HINT
The cellular phone is unable to call under any of the following conditions:

* The cellular phone is locked.
* The directory is being transferred.
* The line is crossed.
* Outside service range
* The power is off.
* The cellular phone is not connected to "Bluetooth" ("BT" is displayed while connected).

OK:

None of the above conditions exist.

NG -- SET CORRECTLY
OK -- Continue to next step.

4. CHECK CELLULAR PHONE

(a) Check if the cellular phone can make a call.

HINT
When the battery is low, calls cannot be made or received.

OK:

Cellular phone can make a call.

NG -- REPAIR OR REPLACE CELLULAR PHONE
OK -- Continue to next step.

5. CHECK RECEPTION

(a) Set the cellular phone so that it can receive calls.

(b) Place the cellular phone close to the radio receiver assembly.

(c) Check if the cellular phone has reception according to the display and navigation module display.

OK:

The cellular phone has reception.

NG -- REPLACE RADIO RECEIVER ASSEMBLY Removal

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table