Disassembly

BRAKE (REAR): REAR BRAKE: DISASSEMBLY

1. REMOVE CYLINDER BOOT

(a) Using a screwdriver with its tip wrapped with vinyl tape, remove the set ring and cylinder boot from the rear disc brake cylinder assembly.





Text in Illustration





NOTICE:
Be careful not to damage the rear disc brake cylinder assembly.

2. REMOVE REAR DISC BRAKE PISTON

(a) Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder assembly.





(b) Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder assembly.

CAUTION:
Do not place your fingers in front of the rear disc brake piston when using compressed air.

NOTICE:
Do not allow any brake fluid to spatter.

3. REMOVE PISTON SEAL

(a) Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the rear disc brake cylinder assembly.





Text in Illustration





NOTICE:
Be careful not to damage the inner cylinder or cylinder groove.

4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

5. REMOVE REAR DISC BRAKE BLEEDER PLUG