Installation

2AZ-FXE ENGINE CONTROL: AIR FUEL RATIO SENSOR: INSTALLATION

1. INSTALL AIR FUEL RATIO SENSOR

(a) Temporarily tighten the air fuel ratio sensor.

(b) Using SST, fully tighten the air fuel ratio sensor.





Text in Illustration





SST : 09224-00010

without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)

with SST - Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)

NOTICE:
* The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
* The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.23 in.).
* This torque value is effective when SST is parallel to the torque wrench Service Precautions.

(c) Connect the air fuel ratio sensor connector.

2. INSPECT FOR EXHAUST GAS LEAK

3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation