Rear Door Unlock Detection Switch RH Circuit

DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: Rear Door UNLOCK Detection Switch RH Circuit
- Rear Door UNLOCK Detection Switch RH Circuit

DESCRIPTION

The rear right side door unlock detection switch is built into the rear right side door lock assembly. The switch turns on when the rear right side door is locked and turns off when the door is unlocked.

The main body ECU RH is connected to the rear right side door lock assembly via terminal LSWR and rear right side door lock/unlock state signals are input to the ECU.

The main body ECU RH applies voltage to the door unlock detection switch via terminal LSWR. When the door unlock detection switch is on (there is continuity between the switch terminals), a lock state signal is input to the ECU. When the switch is off (there is no continuity between the switch terminals), an unlock state signal is input.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING DATA LIST (UNLOCK DETECTION SWITCH)

(a) Check the Data List to ensure proper function of the door unlock detection switch.

Main Body ECU:





OK:

The display is as specified in the normal condition column.

NG -- INSPECT REAR DOOR LOCK ASSEMBLY (UNLOCK DETECTION SWITCH)

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. INSPECT REAR DOOR LOCK ASSEMBLY (UNLOCK DETECTION SWITCH)

(a) Remove the rear door lock assembly RH.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPLACE REAR DOOR LOCK ASSEMBLY
OK -- Continue to next step.

3. CHECK WIRE HARNESS (REAR DOOR LOCK ASSEMBLY - MAIN BODY ECU RH)

(a) Disconnect the rear door lock assembly RH connector.





(b) Disconnect the ECU (cowl side J/B RH) connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE MAIN BODY ECU RH (COWL SIDE J/B RH)