Removal

DOOR LOCK: DOOR CONTROL TRANSMITTER: REMOVAL

1. REMOVE TRANSMITTER BATTERY (for Standard)

NOTICE:
Take extra care when handling these precision electronic components.

(a) Push and hold the release knob in the direction indicated by the arrow in the illustration. Then take the mechanical key out of the case.





(b) for Type A:

(1) Using a screwdriver wrapped with protective tape, insert a precision screwdriver into the gap and turn the screwdriver to detach the cover.





Text in Illustration





HINT
Tape the screwdriver tip before use.

(2) Insert a precision screwdriver into the gap and remove the battery (lithium battery).





NOTICE:
* Do not push the terminals with your finger.
* Do not forcibly pry up the battery. The terminals may be damaged.
* Do not touch the battery with wet hands. Water may cause rust.
* Do not touch or move any components inside the transmitter. It may interfere with proper operation.

(c) for Type B:

(1) Disengage the claw and remove the slide transmitter housing cover as shown in the illustration.





(2) Remove the battery cover with 4 screws.





(3) Insert a precision screwdriver into the gap and remove the battery (lithium battery: CR1632).





NOTICE:
* When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.
* Do not push the terminals with your finger.
* Do not forcibly pry up the battery (lithium battery) because doing so will deform the terminals.
* Do not touch the battery with wet hands. Water may result in corrosion.
* Do not touch or move any components inside the transmitter because handling the components may interfere with proper operation of the transmitter.

2. REMOVE TRANSMITTER (CARD KEY) BATTERY (for Card Type)

(a) Lightly hold and pull the battery cover out in the direction indicated by the arrow in the illustration.





NOTICE:
Do not insert a screwdriver etc. between the case and battery cover and forcefully bend the battery cover. This will deform the battery cover.

HINT
* If the battery cover is held too firmly, it becomes harder to pull out.
* If the cover is slippery and it is difficult to pull it out, use non-slip gloves to pull the cover out.

(b) Remove the transmitter (card key) battery (lithium battery).