Installation
WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Quarter): INSTALLATION
1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Push down on the wire guide and drum, and insert the drum into the power window regulator motor.
NOTICE:
If you cannot insert the drum into the motor, slowly slide the bracket for installing the glass, and insert the drum while aligning the drive shaft of the motor with the drum.
(b) Engage the guide.
(c) Install the rear quarter power window regulator bracket with the 2 screws.
Torque : 1.7 Nm (17 kgf-cm, 15 in-lbf)
2. INSTALL QUARTER WINDOW GLASS FEMALE STABILIZER Installation
3. INSTALL QUARTER WINDOW WITH REGULATOR ASSEMBLY Installation
4. MANUALLY OPEN QUARTER WINDOW ASSEMBLY Installation
5. INSTALL REAR SPEAKER ASSEMBLY Installation
6. INSTALL FRONT SEAT OUTER BELT ASSEMBLY Installation
7. INSTALL LUGGAGE COMPARTMENT DOOR WEATHERSTRIP Installation
8. INSTALL BACK DOOR STOPPER CUSHION LH Installation
9. INSTALL BACK DOOR STOPPER CUSHION RH
HINT
Use the same procedure for the RH side and LH side.
10. INSTALL CENTER PILLAR UPPER END WEATHERSTRIP Installation
11. INSPECT QUARTER WINDOW ASSEMBLY Installation
12. ADJUST QUARTER WINDOW ASSEMBLY Installation
13. INSTALL QUARTER SERVICE HOLE COVER Installation
14. INSTALL QUARTER TRIM BRACKET LH Installation
15. INSTALL QUARTER TRIM BRACKET RH (for RH Side) Installation
16. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH Installation
17. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Installation
18. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH (for RH Side) Installation
19. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH (for RH Side) Installation
20. INSTALL LAP BELT OUTER ANCHOR COVER Installation
21. INSTALL DOOR SCUFF PLATE ASSEMBLY Installation
22. INSTALL REAR SEATBACK ASSEMBLY WITH REAR CONSOLE BOX ASSEMBLY Installation
23. INSTALL REAR SEAT CUSHION ASSEMBLY LH Installation
24. INSTALL REAR SEAT CUSHION ASSEMBLY RH Installation
25. INSTALL PACKAGE TRAY TRIM GARNISH LH Installation
26. INSTALL PACKAGE TRAY TRIM GARNISH RH Installation
27. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
28. CLOSE METAL TOP ROOF
(a) Close the metal top roof.
29. INSPECT SRS WARNING LIGHT
Diagnosis System