Rear View Monitor System

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HINT
Use the following procedure to troubleshoot the rear view monitor system.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

NEXT -- Continue to next step.

3. CUSTOMER PROBLEM ANALYSIS

NEXT -- Continue to next step.

4. CHECK AND CLEAR DTCs

(a) Refer to DTC check/clear Rear View Monitor System.

NEXT -- Continue to next step.

5. PROBLEM SYMPTOM CONFIRMATION

Result:





B -- Go to step 7
A -- Continue to next step.

6. SYMPTOM SIMULATION

NEXT -- Continue to next step.

7. CHECK DTC

Result:





B -- Go to step 11
A -- Continue to next step.

8. CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM

(a) Check the navigation system.

Navigation system (for HDD) Problem Symptoms Table

Navigation system (for DVD) Problem Symptoms Table

Result:





B -- GO TO NAVIGATION SYSTEM (FOR HDD) (FOLLOW NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING)

C -- GO TO NAVIGATION SYSTEM (FOR DVD) (FOLLOW NAVIGATION SYMPTOM CHART TO PERFORM TROUBLESHOOTING)
A -- Continue to next step.

9. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.

Result:





B -- Go to step 12
A -- Continue to next step.

10. OVERALL ANALYSIS AND TROUBLESHOOTING

(a) Terminals of ECU Rear View Monitor System (w/o Navigation System)

NEXT -- Continue to next step.

11. CIRCUIT INSPECTION

NEXT -- Continue to next step.

12. ADJUST, REPAIR OR REPLACE

NEXT -- Continue to next step.

13. CONFIRMATION TEST

NEXT -- END