Installation

THEFT DETERRENT / KEYLESS ENTRY: ENTRY LOCK AND UNLOCK SWITCH: INSTALLATION

1. INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY

(a) Insert the front end of the front door outside handle assembly into the front door outside handle frame.





(b) Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Next, slide the front door outside handle assembly towards the front of the vehicle to install it.

(c) Using a T30 "TORX" socket wrench, install the front door outside handle assembly with the screw.





Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)

(d) Connect the connector.

2. INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side) Reassembly

3. INSTALL FRONT DOOR OUTSIDE HANDLE COVER (for Driver Side) Reassembly

4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER (for Front Passenger Side) Reassembly

5. INSTALL FRONT DOOR SERVICE HOLE COVER

(a) Install the front door service hole cover Reassembly.

(b) Connect the door side airbag sensor connector.

6. INSTALL FRONT DOOR TRIM COVER Reassembly

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

8. INSTALL COURTESY LIGHT ASSEMBLY Installation

9. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Reassembly

10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Installation

11. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH Reassembly

12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG Reassembly

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

14. INSPECT SRS WARNING LIGHT

Diagnosis System

15. INITIALIZE POWER WINDOW CONTROL SYSTEM

Initialization