Removal
DOOR LOCK: FRONT DOOR LOCK: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly
4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH Disassembly
5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL Disassembly
6. REMOVE COURTESY LIGHT ASSEMBLY Removal
7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly
8. REMOVE FRONT DOOR TRIM COVER Disassembly
9. REMOVE FRONT DOOR SERVICE HOLE COVER
(a) Disconnect the door side airbag sensor connector.
(b) Remove the front door service hole cover Disassembly.
10. REMOVE FRONT DOOR UPPER WINDOW STOP Disassembly
11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly
12. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY Disassembly
13. REMOVE FRONT DOOR LOCK ASSEMBLY
(a) Using a T30 "TORX" socket wrench, remove the 3 screws.
(b) Slide the front door lock assembly downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock assembly and cables as a unit.
(c) Remove the front door lock open rod from the front door lock assembly.
(d) Remove the door lock wiring harness seal from the front door lock assembly.
14. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
(a) Remove the front door lock remote control cable assembly.
15. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
(a) Using a screwdriver, disengage the 3 claws.
HINT
Tape the screwdriver tip before use.
(b) Remove the front door inside locking cable assembly.
