Removal

BRAKE (REAR): REAR BRAKE: REMOVAL

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure is for the LH side.

1. REMOVE REAR WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, immediately wash it off.

3. REMOVE REAR DISC BRAKE PAD

(a) Disengage both ends of the anti-squeal spring from the 2 rear disc brake pad holes, and turn the anti-squeal spring as shown in the illustration.





(b) Push the pin hold clip toward the rear disc to disengage it from the rear disc brake pad, and then remove it from the 2 pad guide pins.





NOTICE:
Be sure to remove the pin hold clip as specified above.

(c) Holding the anti-squeal spring, remove the 2 pad guide pins from the rear disc brake cylinder assembly.





(d) Remove the anti-squeal spring from the rear disc brake cylinder assembly.

(e) Remove the 2 rear disc brake pads from the rear disc brake cylinder assembly.

4. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM

(a) Remove the 2 rear disc brake anti-squeal shims from each rear disc brake pad.

5. DISCONNECT REAR FLEXIBLE HOSE

(a) Remove the union bolt, gasket and disconnect the rear flexible hose from the rear disc brake cylinder assembly.





6. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN

(a) Remove the rear disc brake cylinder slide pin.





7. REMOVE CALIPER SUPPORT BRACKET

(a) Tilt the rear disc brake cylinder assembly toward the rear of the vehicle.

(b) Remove the 2 bolts and caliper support bracket together with the rear disc brake cylinder assembly.





8. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY

(a) Remove the rear disc brake cylinder assembly from the caliper support bracket.

9. REMOVE REAR NO. 1 DISC BRAKE CALIPER PLATE

(a) Remove the 2 rear No. 1 disc brake caliper plates from the caliper support bracket.

10. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

11. REMOVE REAR DISC

(a) Put matchmarks on the rear disc and the axle hub.





Text in Illustration





(b) Release the parking brake and remove the rear disc.





HINT
If the disc can not be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.