Installation

2GR-FSE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

1. INSTALL V-RIBBED BELT

(a) Install the V-ribbed belt.





(b) While turning the belt tensioner counterclockwise, remove the bar.

NOTICE:
* Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
* Check that the V-ribbed belt is properly set to each pulley.

(c) If it is difficult to install the V-ribbed belt, perform the following procedure.





Text in Illustration





(1) Put the V-ribbed belt on every part except the tensioner pulley.

(2) Put the V-ribbed belt on the tensioner pulley While turning the belt tensioner counterclockwise.

NOTICE:
* Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
* Check that the V-ribbed belt is properly set to each pulley.

2. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

3. INSTALL NO. 1 INLET AIR CLEANER Installation

4. INSTALL COOL AIR INTAKE DUCT SEAL Installation