Replacement

2GR-FSE LUBRICATION: OIL AND OIL FILTER: REPLACEMENT

CAUTION:
* Prolonged and repeated contact with engine oil will result in removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
* Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Protective clothing and gloves that cannot be penetrated by oil should be worn. The skin should be washed with soap and water, or use waterless hand cleaner, to remove any used engine oil thoroughly. Do not use gasoline, thinners, or solvents.
* In order to preserve the environment, used oil and used oil filters must be disposed of at designated disposal sites.
1. DRAIN ENGINE OIL

(a) Remove the drain plug.

(b) Install a new gasket and the drain plug.

Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)

2. REMOVE OIL FILTER ELEMENT SERVICE HOLE COVER

(a) Remove the 3 screws and service hole cover.





3. REMOVE OIL FILTER ELEMENT

(a) Using SST, remove the oil filter cap.





SST : 09228-06501

HINT
Use a container to catch the draining oil. After the oil filter cap is loosened approximately 4 turns and the cap ribs are vertical, engine oil drains from the gap between the oil filter cap and oil pan.

(b) Remove the oil filter element and O-ring from the oil filter cap.





Text in Illustration





NOTICE:
Do not use any tools to remove the O-ring in order to prevent the cap from being damaged. Be sure to remove it by hand.

4. INSTALL OIL FILTER ELEMENT

(a) Clean the inside of the oil filter cap, the threads and O-ring groove.





Text in Illustration





(b) Apply a small amount of engine oil to a new O-ring and install it to the oil filter cap.

NOTICE:
Make sure that the O-ring does not get twisted on the groove.

(c) Set a new oil filter element to the oil filter cap.

(d) Remove any dirt or foreign matter from the installation surface of the engine.

(e) Apply a small amount of engine oil to the O-ring again and install the oil filter cap.

(f) Using SST, tighten the oil filter cap.





SST : 09228-06501

Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)

NOTICE:
* Make sure that the oil filter is installed securely as shown in the illustration.
* Be careful that the O-ring does not get caught between the parts.

5. ADD ENGINE OIL

(a) Add clean engine oil.

Standard Engine Oil:





Standard Capacity:





6. INSPECT FOR COOLANT LEAK

(a) Start the engine. Make sure that no oil leaks from the connection point of the oil filter cap.

7. CHECK ENGINE OIL LEVEL Testing and Inspection

8. INSTALL OIL FILTER ELEMENT SERVICE HOLE COVER

(a) Install the service hole cover with the 3 screws.