Tire Pressure Warning Light Circuit

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: Tire Pressure Warning Light Circuit
- Tire Pressure Warning Light Circuit

DESCRIPTION

If the tire pressure warning ECU and receiver detects a malfunction, the tire pressure warning light comes on and tire pressure warning system is cancelled at the same time. At this time, the tire pressure warning ECU and receiver records a DTC in the memory.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
It is necessary to perform initialization Initialization after registration Registration of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU and/or one of the valve and transmitters have been replaced.

HINT
This procedure must be performed according to Problem Symptoms Table Symptom Related Diagnostic Procedures.

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Check the condition of the tire pressure warning light by operating the Techstream. Enter the following menus: Body / Combination Meter / Active Test.

Combination Meter





OK:

The tire pressure warning light is normal.

NG -- REPLACE COMBINATION METER Removal
OK -- Continue to next step.

2. CHECK MULTIPLEX COMMUNICATION SYSTEM

(a) Check the multiplex communication system Multiplex Communication System.

OK:

There is not a malfunction in the multiplex communication system.

NG -- GO TO MULTIPLEX COMMUNICATION SYSTEM How to Proceed With Troubleshooting

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures