Installation

AXLE AND DIFFERENTIAL: FRONT AXLE HUB: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

(a) Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.





Torque : 69 Nm (704 kgf-cm, 51 ft-lbf)

NOTICE:
* Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle and front disc brake dust cover.
* Do not allow any foreign matter such as dirt or dust to enter between the front disc brake dust cover and front axle hub sub-assembly.

2. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

3. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub

4. INSTALL FRONT DISC

for Floating Type Caliper Installation

for Opposed Type Caliper Installation

5. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Replacement

6. CONNECT FRONT SPEED SENSOR WIRE Installation

7. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

8. CHECK FOR SPEED SENSOR SIGNAL

Test Mode Procedure.