Stop Light Switch Circuit Malfunction
CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P0571: Stop Light Switch Circuit Malfunction
P0571 - Stop Light Switch Circuit Malfunction
DESCRIPTION
The ECM receives the brake demand signal from the distance control ECU and transmits it to the brake actuator (skid control ECU).
The brake actuator (skid control ECU) receives a signal from the ECM and operates the brake actuator.
The brake actuator (skid control ECU) operates the brake actuator and at the same time illuminates the stop light by operating the BRK-LP relay.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK STOP LIGHT OPERATION
(a) Check that the stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.
Result:
OK:
When the brake pedal is operated, the illumination changes as shown above.
NG -- GO TO PROBLEM SYMPTOMS TABLE (STOP LIGHT SYSTEM) Exterior Lighting System
OK -- Continue to next step.
2. CHECK BRK-LP RELAY
(a) Turn the engine switch off.
(b) Remove the BRK-LP relay from the engine room No. 3 relay block.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE BRK-LP RELAY
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (ENGINE ROOM NO. 3 RELAY BLOCK - BATTERY)
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (ENGINE ROOM NO. 3 RELAY BLOCK - SKID CONTROL ECU)
(a) Disconnect the connector from the brake actuator (skid control ECU).
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Disconnect the connector from the brake actuator (skid control ECU).
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (STOP LIGHT CONTROL RELAY - SKID CONTROL ECU)
(a) Disconnect the connector from the stop light control relay.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE BRAKE ACTUATOR (SKID CONTROL ECU) Components