Installation

FRONT SUSPENSION: FRONT SUSPENSION MEMBER: INSTALLATION

1. INSTALL POWER STEERING LINK ASSEMBLY

(a) Install the power steering link assembly with the 2 bolts, 2 washers, and 2 nuts.





Torque : 118 Nm (1203 kgf-cm, 87 ft-lbf)

HINT
Install the power steering link assembly together with the front lower suspension arm assembly.

2. INSTALL FRONT LOWER SUSPENSION ARM ASSEMBLY LH

(a) Install the front suspension lower arm assembly LH with the 2 bolts, 2 nuts and 2 washers.





Bolt B - Torque : 87 Nm (887 kgf-cm, 64 ft-lbf)

HINT
Install the power steering link assembly together with the front lower suspension arm assembly.

(b) Set the front lower suspension arm in the horizontal position shown in the illustration.





(c) Fully tighten the bolt A.

Bolt A - Torque : 135 Nm (1377 kgf-cm, 100 ft-lbf)

NOTICE:
The final torque must be applied under standard vehicle height conditions.

3. INSTALL FRONT LOWER SUSPENSION ARM ASSEMBLY RH

HINT
Perform the same procedure as the LH side.

4. INSTALL FRONT STABILIZER BAR

(a) Install the front stabilizer bar with the 2 nuts.





Torque : 84 Nm (857 kgf-cm, 62 ft-lbf)

HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.

5. INSTALL FRONT ENGINE MOUNTING INSULATOR Installation

6. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Installation

7. INSTALL NO.2 EXHAUST MANIFOLD HEAT INSULATOR Installation

8. INSTALL NO.1 EXHAUST MANIFOLD HEAT INSULATOR Installation

9. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY LH Installation

10. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY RH Installation

11. INSTALL OIL LEVEL DIPSTICK GUIDE Installation

12. INSTALL OIL LEVEL DIPSTICK

13. INSTALL ENGINE WITH TRANSMISSION ASSEMBLY

HINT
Install the engine with transmission assembly. Installation