Reassembly

SLIDING ROOF / CONVERTIBLE: SLIDING ROOF HOUSING: REASSEMBLY

1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

(a) Hold down the window deflector.





NOTICE:
Make sure that the spring indicated by the arrow in the illustration is securely installed.

(b) Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.





(c) Engage the 2 claws and install the sliding roof drip channel.





(d) Install the 2 sliding roof side stoppers with the 2 screws.





Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

2. ADJUST FULLY CLOSED POSITION

(a) Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction as indicated by the arrows in the illustration and align the matchmarks.





HINT
Tape the screwdriver tip before use.

3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

(a) Insert the sunshade trim into the sliding roof housing sub-assembly.

(b) Install the sliding roof piece sub-assembly LH and RH with the 2 screws.





Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf)

4. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

(a) Install the sliding roof drive gear sub-assembly with the 2 bolts.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(b) Engage the claw and install the sliding roof drive gear bracket.