Slip Indicator Light Remains ON
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light Remains ON
- Slip Indicator Light Remains ON
DESCRIPTION
The skid control ECU is connected to the combination meter via the CAN and multiplex communication systems.
If the skid control ECU stores a DTC, the slip indicator light will come on in the combination meter.
The slip indicator light blinks during VSC and/or TRAC operation.
When the system fails, the slip indicator light comes on to warn the driver Diagnosis System.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration and store system information Programming and Relearning.
PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
(a) Check if a CAN communication system DTC is output Diagnosis System.
Result:
B -- INSPECT CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.
2. CHECK MULTIPLEX COMMUNICATION SYSTEM
(a) Check if a multiplex communication system DTC is output Multiplex Communication System.
Result:
B -- INSPECT MULTIPLEX COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.
3. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
(a) Check if the skid control ECU connector is securely connected.
OK:
The connector is securely connected.
NG -- CONNECT CONNECTOR TO ECU CORRECTLY
OK -- Continue to next step.
4. CHECK BATTERY
(a) Check the battery voltage.
Standard Voltage:
11 to 14 V
NG -- CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (for 2UR-GSE) Testing and Inspection
OK -- Continue to next step.
5. INSPECT COMBINATION METER ASSEMBLY
(a) Perform the Active Test of the combination meter (meter CPU) using the Techstream Scan Tool Testing and Procedures.
(b) Check the combination meter.
OK:
The slip indicator light turns on or off in accordance with the Techstream operation.
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Problem Symptoms Table.
NG -- REPLACE COMBINATION METER ASSEMBLY Removal
OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal