Disassembly

PARKING BRAKE: PARKING BRAKE ASSEMBLY: DISASSEMBLY

HINT
When removing the parking brake anchor block sub-assembly, refer to the instructions for Removal of the rear axle hub and bearing assembly Removal.

1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CYLINDER ASSEMBLY

(a) Remove the 2 bolts and separate the rear disc brake cylinder assembly.





NOTICE:
Hang the caliper with wire or equivalent.

3. REMOVE REAR DISC Removal

4. REMOVE NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING

(a) Using SST, remove the No. 2 parking brake shoe return tension spring.

SST : 09703-30011





5. REMOVE NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING

(a) Using SST, remove the No. 1 parking brake shoe return tension spring.

SST : 09703-30011





6. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET

(a) Spread apart the No. 1 parking brake shoe assembly and No. 2 parking brake shoe assembly, and remove the parking brake shoe adjusting screw set.





7. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY

(a) Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.

SST : 09718-00011





(b) Remove the No. 1 parking brake shoe assembly.

HINT
Use the service hole to retain the No. 1 shoe hold down spring pin.

8. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY

(a) Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.

SST : 09718-00011





(b) Remove the No. 2 parking brake shoe assembly.

HINT
Use the service hole to retain the No. 1 shoe hold down spring pin with your finger.

9. REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY

(a) Remove the parking brake shoe lever sub-assembly.