Procedures

2UR-GSE ENGINE MECHANICAL: CYLINDER BLOCK: REPLACEMENT

1. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pins unless they are being replaced.

(a) Remove the straight pins.

(b) Using a plastic-faced hammer, tap in new straight pins to the cylinder block.





Standard Protrusion:





2. REPLACE STUD BOLT

NOTICE:
If a stud bolt is deformed or the threads are damaged, replace it.

(a) Remove the stud bolts.

(b) Using E8 and E10 "TORX" socket wrenches, install the stud bolts.





Bolt A - Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

Bolt B - Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)