Installation

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING ECU: INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY

(a) Install the tire pressure warning receiver assembly.





(b) Install the bolt.





Torque : 3.5 Nm (36 kgf-cm, 31 in-lbf)

2. INSTALL INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (w/o Navigation System) Installation

3. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (w/ Navigation System) Installation

4. INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Installation

5. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Installation

6. INSTALL FRONT ASH RECEPTACLE ASSEMBLY Installation

7. INSTALL CONSOLE PANEL SUB-ASSEMBLY Installation

8. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH Installation

9. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH Installation

10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

12. REGISTER OF TRANSMITTER ID

Registration.

13. INSPECT TIRE PRESSURE WARNING SYSTEM

Test Mode Procedure.