Removal
SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: REMOVAL
HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. REMOVE REAR SEAT HEADREST ASSEMBLY LH
4. REMOVE REAR SEAT HEADREST ASSEMBLY RH
5. REMOVE REAR SEAT CUSHION ASSEMBLY Removal
6. REMOVE REAR SEATBACK ASSEMBLY Removal
7. REMOVE REAR DOOR SCUFF PLATE Removal
8. REMOVE REAR SEAT SIDE GARNISH Removal
9. REMOVE REAR AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connector from the rear airbag sensor.
NOTICE:
When disconnecting the airbag connector, take care not to damage the airbag wire harness.
(d) Remove the bolt and disengage the pin, and remove the rear airbag sensor.
NOTICE:
Loosen the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.