Operation CHARM: Car repair manuals for everyone.

Installation





SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: INSTALLATION

1. INSTALL SEAT POSITION SENSOR

(a) Install the seat position sensor to the seat position sensor protector with the pin as shown in the illustration.





(b) Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position sensor with the seat position sensor protector.





NOTICE:
* If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
* When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

HINT
Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).

(c) Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor with the seat position sensor protector.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).

(e) Connect the connector.

NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

(f) Check that there are no loose parts after installing the seat position sensor.

2. INSTALL FRONT SEAT ASSEMBLY LH

(a) Install the front seat assembly LH Installation.