TC and CG Terminal Circuit

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: TC and CG Terminal Circuit
- TC and CG Terminal Circuit

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.

DTCs are displayed by the tire pressure warning light blinking pattern.

WIRING DIAGRAM





HINT
When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM AND MULTIPLEX COMMUNICATION SYSTEM

(a) Check it a DTC of CAN communication system and multiplex communication system is output.

Result:





C -- REPAIR CIRCUITS INDICATED BY OUTPUT DTCS How to Proceed With Troubleshooting

B -- REPAIR CIRCUITS INDICATED BY OUTPUT DTCS Multiplex Communication System
A -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (ECM - DLC3)

(a) Disconnect ECM A6 connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. INSPECT DLC3 TERMINAL VOLTAGE

(a) Turn the engine switch on (IG).





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





NG -- REPLACE ECM Removal
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER Removal