Installation

WIPER / WASHER: RAIN SENSOR: INSTALLATION

1. INSTALL RAIN SENSOR TAPE

(a) Peel off the releasing sheet (yellow side) and attach the rain sensor tape on the position indicated in the illustration (the sensor part of the rain sensor) while pushing out air bubbles with fingers.





(b) Peel off the releasing sheet (white side).

NOTICE:
* When reusing the rain sensor, clean up dirt on the sensor part with a piece of cloth, etc.
* Do not touch the sensor tape surface directly with fingers.





2. INSTALL RAIN SENSOR

(a) Connect the connector.

(b) Engage the claw as shown in the illustration to set the position.





(c) Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming in between them.

(d) Push in the stopper.





NOTICE:
* Do not touch the sensor tape surface and the glass surface directly with fingers.
* Clean up dirt on the glass with a piece of cloth, etc.
* After installing the rain sensor, there should be no air bubbles between the windshield glass and the rain sensor tape.