Installation
AUDIO / VISUAL: AMPLIFIER ANTENNA: INSTALLATION
1. INSTALL AMPLIFIER ANTENNA ASSEMBLY
(a) Use non-residue solvent to clean the area on the glass where the antenna will be installed.
NOTICE:
Do not use non-residue solvent to clean the antenna's contact points. Doing so may cause improper contact between the antenna and glass.
(b) Install the antenna with the 2 nuts labeled B.
Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)
NOTICE:
* Just before installing the antenna to the glass, remove the protective cover of the antenna's contact points.
* When removing the protective cover of the antenna's contact points, make sure the cover does not touch the contact points.
* Never touch the contact points after removing the protective cover.
* Do not reuse the clip labeled A.
(c) Attach the 4 clips labeled C.
(d) Connect the antenna connectors.
(e) Return the roof headlining to its original position.
for Standard Body: Refer to the following procedures Installation.
for Long Body: Refer to the following procedures Installation.
2. INSTALL ASSIST GRIP SUB-ASSEMBLY Installation
3. INSTALL ROOF SIDE REGISTER BEZEL RH (w/ Rear Cooler) Installation
4. INSTALL ROOF SIDE REGISTER BEZEL LH (w/ Rear Cooler) Installation
5. INSTALL COAT HOOK Installation
6. INSTALL REAR VANITY LIGHT ASSEMBLY Installation
7. INSTALL SPOT LIGHT ASSEMBLY Installation
8. INSTALL ROOF CONSOLE BOX ASSEMBLY (for Long Body) Installation
9. INSTALL SPOT LIGHT LENS (for Long Body) Installation
10. INSTALL ROOF SIDE GARNISH INNER RH Installation
11. INSTALL ROOF SIDE GARNISH INNER LH Installation
12. INSTALL REAR SEAT SIDE GARNISH RH Installation
13. INSTALL REAR SEAT SIDE GARNISH LH Installation
14. INSTALL REAR DOOR SCUFF PLATE RH
(a) for Standard Body:
(1) Install the rear door scuff plate RH Installation.
(b) for Long Body:
(1) Install the rear door scuff plate RH Installation.
15. INSTALL REAR DOOR SCUFF PLATE LH
(a) for Standard Body:
(1) Install the rear door scuff plate LH Installation.
(b) for Long Body:
(1) Install the rear door scuff plate LH Installation.
16. INSTALL REAR SEAT ASSEMBLY
(a) for Power Seat:
Install the rear seat assembly Installation.
(b) for 4-Passenger with Ottoman:
Install the rear seat assembly Installation.
(c) for 5-Passenger with Ottoman:
Install the rear seat assembly Installation.
(d) for Fixed Seat:
Install the rear seat assembly Installation.
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
18. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
19. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.