Safety Connect System

CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: DCM POWER SOURCE CIRCUIT
- DCM POWER SOURCE CIRCUIT

DESCRIPTION

This is the power source circuit to operate the DCM (telematics transceiver).

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (DCM - BATTERY AND BODY GROUND)

(a) Disconnect the L111 DCM (telematics transceiver) connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table