Removal

1UR-FSE ENGINE CONTROL SYSTEM: AIR FUEL RATIO SENSOR (for 2WD): REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

4. REMOVE AIR CLEANER INLET COVER Removal

5. REMOVE NO. 1 AIR CLEANER INLET Removal

6. REMOVE NO. 1 ENGINE UNDER COVER Service and Repair

7. REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER Removal

8. REMOVE NO. 2 ENGINE UNDER COVER Removal

9. REMOVE INTAKE AIR CONNECTOR PIPE Removal

10. REMOVE V-RIBBED BELT Removal

11. REMOVE GENERATOR ASSEMBLY Removal

12. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Remove the front exhaust pipe Removal.

13. REMOVE STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY (w/ VGRS) Removal

14. REMOVE STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY (w/o VGRS) Removal

15. REMOVE STEERING INTERMEDIATE SHAFT (w/o VGRS) Removal

16. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (w/ VGRS) Removal

17. REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (w/o VGRS) Removal

18. REMOVE ENGINE UNDER COVER REAR LH

19. REMOVE ENGINE UNDER COVER REAR RH

20. REMOVE FRONT STABILIZER BAR Removal

21. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY LH

22. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY RH

23. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH

24. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

25. REMOVE OIL DIPSTICK GUIDE Removal

26. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR Removal

27. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal

28. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Removal

29. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH Removal

30. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)





(a) Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.

SST : 09224-00010

31. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)





(a) Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

SST : 09224-00010