Wheel Hub: Testing and Inspection

AXLE: REAR AXLE HUB: ON-VEHICLE INSPECTION

1. REMOVE REAR WHEEL

2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH Removal

3. REMOVE REAR DISC Removal

4. INSPECT REAR AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, check for looseness near the center of the axle hub.





Maximum:

0.05 mm (0.0020 in.)

NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface.

If the looseness exceeds the maximum, replace the axle hub.

5. INSPECT REAR AXLE HUB RUNOUT

(a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.





Maximum:

0.05 mm (0.0020 in.)

NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface.

If the runout exceeds the maximum, replace the axle hub.

6. INSTALL REAR DISC Installation

7. ADJUST PARKING BRAKE SHOE CLEARANCE Adjustments

8. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH Installation

9. INSTALL REAR WHEEL

Torque : 140 Nm (1428 kgf-cm, 103 ft-lbf)