Installation

MIRROR: OUTER REAR VIEW MIRROR: INSTALLATION

HINT
* Use the same procedures for the LH side and RH side.
* The procedures listed below are for the LH side.
* A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY





(a) Install the mirror with the 3 nuts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Attach the 3 clamps.

(c) Connect the connector.

2. INSTALL FRONT NO. 2 DOOR SERVICE HOLE COVER Installation

3. INSTALL FRONT MULTIPLEX NETWORK DOOR ECU Installation

4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Installation

5. INSTALL DOOR FRAME GARNISH Installation

6. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY Installation

7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG Installation

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. INSTALL BATTERY SERVICE HOLE COVER LH Installation

10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation