Installation

2UR-FSE ENGINE CONTROL SYSTEM: ECM: INSTALLATION

1. INSTALL ECM

(a) Install the 2 ECM brackets with the 4 screws.

(b) Install the ECM with the 2 nuts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)





(c) Connect the 6 ECM connectors.

2. CONNECT NO. 2 CONNECTOR HOLDER

(a) Attach the 2 claws to connect the connector holder.





(b) Connect the 2 engine wire connectors.

3. INSTALL HYBRID VEHICLE CONTROL ECU

(a) Install the ECU with the 2 nuts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)





(b) Connect the 4 ECU connectors.

4. INSTALL ENGINE ROOM ECU COVER





(a) Install the ECU cover with the 3 bolts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

5. INSTALL ENGINE ROOM SIDE COVER LH Installation

6. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. INSTALL BATTERY SERVICE HOLE COVER LH Installation

9. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation

10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation