ABS Control System Malfunction

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: 36,43: ABS Control System Malfunction
43 - ABS Control System Malfunction

DESCRIPTION

These DTCs are stored if the VSC and/or electronically controlled brake system detects a malfunction in the ABS control system.





INSPECTION PROCEDURE

NOTICE:
When replacing the brake booster with master cylinder (skid control ECU), perform initialization and calibration of the linear solenoid valve Initialization.

PROCEDURE

1. CHECK ABS CONTROL SYSTEM

(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(b) Turn the power switch on (READY).

(c) Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

(d) Check if the same DTC is recorded Reading and Clearing Diagnostic Trouble Codes.

Result:





B -- REPAIR CIRCUITS INDICATED BY OUTPUT DTCS Electronically Controlled Brake System
A -- Continue to next step.

2. RECONFIRM DTC

(a) Turn the power switch off.

(b) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(c) Turn the power switch on (READY).

(d) Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

(e) Check if the same DTC is recorded Reading and Clearing Diagnostic Trouble Codes.

Result:





B -- REPLACE BRAKE BOOSTER WITH MASTER CYLINDER Removal

A -- CHECK FOR INTERMITTENT PROBLEMS How To Proceed With Troubleshooting